of weight on the top center of the track. You can also use a torque wrench, tightening both used and new plugs to 13 ft-lbs. If you’re installing a new plug, turn it 180 degrees to crush the sealing washer. If the plug was used previously, turn it an additional 90 degrees.
When installing the plug, turn it until you feel it seat. Some wear is normal, but the plug will need to be replaced sooner than recommended if the insulator or electrodes are damaged. The gap between the electrodes should be between 0.028 and 0.031 inches. The drive chains for the tracks should be lubricated with Hondalube graphite or moly chain lube, or an equivalent high-quality lubricant. – On the sliding part of the levers, between the lever and the mount. – On the sliding surface where the chute meets the auger housing – On the guides, the bolts slide on to adjust the chute angle There are three points on the snow blower that should be lubricated with waterproof grease: When filling, the oil should reach the edge of the filler neck. To get an accurate measurement, check the oil with the blower on a flat surface and do not screw in the oil filler cap/dipstick. When draining the oil, use a wrench to keep the drain extension in place while you unscrew the drain bolt. The GX390 engine that powers these blowers is designed to use 5W-30 oil for gasoline engines. The starter is protected by a 5 amp fuse, located in a cover next to the battery. Next, push down on the battery strap to unhook it from the base. When removing the battery, disconnect the smaller negative terminal first, followed by the positive terminal. Charging should take between 5 and 10 hours. Honda recommends limiting current to two amps. If it reads below 12.9 volts, the battery needs to be recharged. To open the box, pull down on the rubber strap to release it from the pin, then tilt the top of the box top up and forward.Ĭheck the output of the battery with a multimeter. This battery is stored in a box directly behind the gas tank. The HSS1332ATD comes equipped with an electric starter powered by a battery. – Charge the battery on electric start (ATD) models Battery – Drain fuel system and clean carburetor sediment cup.
This includes cable adjustment and auger transmission maintenance.
– Have your snow blower serviced professionally. – Charge the battery on electric start (ATD) models – Replace the Spark Plug Getting Your Snow Blower Out of Storage: – Check the bolts and fasteners on the machine for tightnessĮvery 300 hours or Four Years of Ownership: – Check the scraper and shoes, adjusting as needed. Here’s everything you need to know to take care of basic maintenance tasks on these Honda snow blowers. The HSS1332AT and HSS1132ATD are powerful machines, but like any piece of equipment, they only work well when they’re maintained.
0 kommentar(er)
